Honeywell OMNI 408 Installation And Setup Manual page 62

OMNI-408/OMNI-408EU Installation and Setup Guide
expires, the Exit Error code is not sent. If an alarm results, the zone's Alarm code is sent before the
Exit Error code.
RECENT PANIC CS REPORTING - This feature is intended to reduce false alarms. Enable this
feature by placing a CS Report code other than "A" in Question 30, Location 4. This feature involves
only the use of the Model 5804 RF key. This CS code is sent if a (5804) panic alarm occurs followed
within 1 minute by a (5804) arm/disarm type event. The 5804 arm/disarm programmable events
include disarm, force arm, force stay arm, force instant arm, and force stay/instant arm.
Tripping an RF panic starts the 1-minute timer. At this time, the control panel attempts to send a
keypad panic. If an RF arm or disarm event occurs within 1 minute, the panel sends the Recent Panic
CS code upon the execution of the RF arm or disarm.
NOTE: Subsequent RF arms or disarms will not cause additional Recent Panic CS transmissions.
If the 1-minute timer expires without an RF arm or disarm, the Recent Panic code (recent close (459) if
PID) is not sent; only the initial Panic code is sent.
QUESTION 31
RF REMOTE KEYFOB 1 BUTTON DEFINITIONS
Question 31, L1 - RF Remote Keyfob 1 Button 1
Question 31, L2 - RF Remote Keyfob 1 Button 2
Question 31, L3 - RF Remote Keyfob 1 Button 3
Question 31, L4 - RF Remote Keyfob 1 Button 4
In Locations L1-L4, enter the digit for the desired system options from the table below.
Digit BUTTON OPERATION
0 Disabled
1 Disarm
2 Arm System
3 Arm Stay
4 Arm Instant
5 Arm Stay/Instant
6 Keypad Fire
7 Keypad Panic
8 Keypad Aux
9 Toggle Trigger 1
A Toggle Trigger 2
B Momentary Trigger 1
C Momentary Trigger 2
D Dual Panic
7–30
EXPLANATION
Not working.
Pressing Button Disarms System.
Pressing Button Arms System.
Pressing Button Arms System in Stay Mode.
Pressing Button Arms System in Instant Mode.
Pressing Button Arms System in Stay/Instant Mode.
Pressing Button Activates Keypad Fire.
Pressing Button Activates Keypad Panic.
Pressing Button Activates Keypad Aux.
Pressing Button Activates Trigger 1.
Pressing Button Activates Trigger 2.
Pressing Button Momentarily Activates Trigger 1.
Pressing Button Momentarily Activates Trigger 2.
Pressing two buttons with this value at the same time activates
keypad panic.
DEFAULT = 0000
Default = 0
Default = 0
Default = 0
Default = 0