Honeywell OMNI 408 Installation And Setup Manual page 101

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
THIS EQUIPMENT SHOULD BE INSTALLED IN
ACCORDANCE WITH THE NATIONAL FIRE
PROTECTION ASSOCIATION'S STANDARD
72, CHAPTER 2(NATIONAL FIRE PROTECTION
ASSOC., BATTERY-MARCH PARK,QUINCY,MA
02269)PRINTED INFORMATION DESCRIBING
PROPER INSTALLATION,OPERATION TESTING,
MAINTENANCE, EVACUATION PLANNING AND
REPAIR SERVICE IS TO BE PROVIDED WITH THIS
EQUIPMENT.
UL INSTALLATIONS REQUIRE LISTED END-OF-LINE
SERVICE. USE RESISTOR FROM EOL22 KIT.
LOOK FOR LISTING MARK ON ITEM
Summary of Connections
ANTENNA 1
JP1 JP2
SYSTEM DEFAULT
RESET JUMPERS
FUSES:
F3 F1 F2
+
IMPORTANT
ALL CONTROL PANEL WIRING SHOULD BE COM-
PLETED PRIOR TO APPLYING POWER TO AVOID
POSSIBLE HARM TO CIRCUITS DUE TO ELECTRO-
STATIC DISCHARGE
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES.
OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARM-
FUL INTERFERENCE, AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
Summary of Connections
DIRECT PLUG-IN
(Wireless Zones)
RF RECEIVER
WARNING
To prevent risk from
electrical shock,
de-energize the system
control unit and disconnect
the telephone lines before
servicing this unit.
Zones 1-4 can be
handwired or wireless.
Zones 5-8 can only be wireless.
ARMED 1 2 3
STAY
READY BYPASS 4 5 6
INSTANT 7 8 9
0 #
CODE
USE WITH XK108 OR
OMNI-LCD, OMNI-LCD-US,
XK7LC, OMNI-KP AND
OMNI-KP-US
THIS UNIT INCLUDES AN ALARM VERIFICATION
FEATURE THAT WILL RESULT IN A DELAY OF THE
SYSTEM ALARM SIGNAL FROM THE INDICATED
CIRCUITS. THE TOTAL DELAY (CONTROL UNIT
PLUS SMOKE DETECTOR) SHALL NOT EXCEED 60
SECONDS. NO OTHER INITIATING DEVICES SHALL
BE CONNECTED TO THESE CIRCUITS UNLESS
APPROVED BY THE LOCAL AUTHORITY HAVING
JURISDICTION.
A P P E N D I X
ANTENNA 2
NOTE
WARNING
ONMI408-SOC-V2
F
F–1