Honeywell OMNI 408 Installation And Setup Manual page 35

QUESTION 04
ACCOUNT NUMBER 1
Enter the 3- or 4-digit subscriber account number for central station phone number 1. If a 3-digit
number is used, then enter an "A" as the fourth digit. Valid entries are 0-9, and B-F. The value "A" is
interpreted as the null value for account numbers.
QUESTION 05
ACCOUNT NUMBER 2
Enter the 3- or 4-digit subscriber account number for central station phone number 2. If a 3-digit
number is used, then enter an "A" as the fourth digit. Valid entries are 0-9, and B-F. The value "A" is
interpreted as the null value for account numbers. If the second phone number is not used, this
question can be left as factory-defaulted.
THIS ACCOUNT NUMBER MUST BE ENTERED IF YOU HAVE PROGRAMMED A SECOND
RECEIVER PHONE NUMBER FOR BACKUP, SPLIT REPORTING, OR PAGER FOLLOW-ME.
QUESTION 06
CS DIALER OPTIONS
There are 4 locations (L1-L4) within this question, which define various dialer and system options, as
follows:
Question 06, L1
CS Dialer Formats
Enter the digit for the desired dialer format from the table below in Location L1.
CS REPORTING
Digit FORMAT
0 3X1 Standard
1 4x1 Standard
2 3x1 Extended
3 4x1 Extended
4 3x1 Partial Extended
5 4x1 Partial Extended
6 3x2
7 4x2
A ADEMCO 4x2 Express *
E Contact ID ® *
Question 06, L2
CS Receiver Type
Enter the digit for the desired receiver type from the table below in Location L2.
FORMAT
TRANSMISSION TYPE
PULSE
PULSE
PULSE
PULSE
PULSE
PULSE
PULSE
PULSE
DTMF
DTMF
Section 7 - System Programming
OMNI-408
OMNI-408EU DEFAULT = E031
* These formats require a high/low
handshake frequency from the CS receiver.
For more information on CS
reporting formats, refer to Appendix
A at the back of this guide.
DEFAULT = 1234
DEFAULT = AAAA
DEFAULT = E011
Default = E
Default = 0
7–3