Change In The Air Outlet Direction (Rpfi Units); Rpf: Optional Pc-Arfpe Remote Control Location - Hitachi RCI-1.0FSN4 Service Manual

2 Unit installation
RPF - Floor type, RPFI - Floor concealed type
RPF units: carry out the above operation after removing
the front and side covers of the unit.
RPFI unit: install the optional air outlet grille as indicated
in the figure.
?
N O T E
• Condensation may be accumulated if the unit is installed in
a very damp place. Install a porous, water-absorbent plastic
plate to absorb and retain water around the grille.
• The optional air outlet grille of the RPFI unit cannot be used
in very damp places, such as a kitchen or bathroom, as
condensation may settle on its surface.
RPFI units: Install an additional access cover attached
with screws so as not to touch the fan duct directly.

2.9.3 Change in the air outlet direction (RPFI units)

The air outlet direction of the unit can be modified to adapt it to installation requirements, as shown in the illustration.
1 Lift air outlet -A-.
2 Turn the air outlet on itself until it is opposite its initial position.
3 Tilt the air outlet so that the nozzle is facing forwards.
4 Refit air outlet -A-.

2.9.4 RPF: Optional PC-ARFPE remote control location

It is possible to install the PC-ARFPE remote control below the plastic cover, as shown in the figure.
66 SMGB0099 rev.0 - 12/2016
A
1
2
2
3
Side cover
Fixing bolt
Fixing bolt
Fixing screws
Absorbent plate for water
Air outlet flange
Floor concealed
unit
Air outlet duct
(field supplied)
4
Front cover
Adjustment bolt
for installation
(accessories)
Polyurethane
foam for thermal
insulation
(field supplied)