Removal Of The Inlet Air Thermistor - Hitachi RCI-1.0FSN4 Service Manual

9 Servicing
RCIM-(0.6-2.5)FSN4(E) - 4-way cassette (compact)
6 Once replaced, fit the electronic expansion valve in the reverse
manner as indicated for the removal process.
7 Position the butyl sheet, attaching it correctly to the valve.
?
N O T E
Check that the cables do not touch the fan duct after installation is complete.

9.2.12 Removal of the inlet air thermistor

1 Remove the air inlet thermistor.
2 Remove the bell-mouth as described in
3 Tear off the filament tape, then remove the thermistor cable attached to the bell-mouth.
4 Push the thermistor case to the direction shown in the picture below to remove the air inlet thermistor with the
thermistor case.
266 SMGB0099 rev.0 - 12/2016
"9.2.5 Removal of the fan runner and the fan motor"
Thermistor cable with
filament tape
Thermistor case
Bell-mouth
Electronic expansion valve coil
Electronic expansion
valve body
(6)
Blue
Electronic expansion
Bell-mouth
Thermistor case
(4)
Yellow
(1)
Red
(3)
(5)
White
Orange
(2)
Free
valve connector