Removal Of The Front Panel - Hitachi RCI-1.0FSN4 Service Manual

9 Servicing
RPF(I)-(1.0-2.5)FSN2E - Floor and Floor concealed type

9.10.4 Removal of the front panel

1 Remove the central panel air filter in line with the instructions
given in chapter "9.10.2 Removal of the air
2 Remove the screws from the lower part of the front panel.
?
N O T E
• RPF-(1.0-2.5)FSN2E: 4 screws.
• RPFI -1.0FSN2E: 9 screws.
• RPFI -1.5FSN2E: 10 screws.
3 Remove the 11 set screws and remove the front panel.
9.10.5 Removal of the fan motor
1 Remove the air inlet grille as indicated in chapter
2 Remove the air filter as indicated in section "9.10.2 Removal of the air
3 Remove the four set screws from the fan motor assembly plate and remove it.
4 Disconnect the wiring from the fan motor connector. Remove the wiring board and the connector.
5 Remove the cover by pressing the four attachment points inwards.
6 Loosen the bolts using a wrench.
7 Remove the securing plate.
8 Remove the fan motor by sliding it backwards.
?
N O T E
Be careful when releasing the fan motor, as it could fall.
333 SMGB0099 rev.0 - 12/2016
filter".
"9.10.1 Removal of the air inlet
filter".
Front
panel
Screw
Front lower panel
grille".
Screw
9