Hitachi RCI-1.0FSN4 Service Manual page 323

9 Servicing
RPK-FSN(H)3M - Wall mounted
Attaching flat panel.
Insert completely the left and right arm shafts of flat panel into
the holes along the guide at the front panel. After the flat panel is
attached completely, insert the catches for air filter to fix it.

For RPK-(2.0-4.0)FSN(H)3M
1 Remove the air filter according to the "9.9.1 Removal of the air filter"
2 Open the flat panel fully and push the right arm shaft inward. After the shaft is removed from the front panel, pull the
flat panel frontward with the right arm shaft slightly pushed inward and then remove the flat panel.
3 Remove 3 bushes and then 3 screws. Pull the lower side of the front panel (2 portions) forward to release the
catches. Use a slotted screwdriver when the catches are difficult to release.
!
C A U T I O N
Take special care not to be injured by the heat exchanger fins.
4 Remove the front panel carefully so that it does not touch the horizontal louver attached to the air outlet. Slightly lift
the front panel up to release the catches (4 portions) on the upper side of the unit. Then pull the front panel forward to
remove it.
?
N O T E
When releasing the catches, snap sound is heard. This is the sound made when the catches are released and so there are no safety
concerns.
Push the shaft
toward arrow
direction
Flat panel
309 SMGB0099 rev.0 - 12/2016
Remove this part
from the hole
Screw
Bush
When using a slotted
screwdriver, insert
it into the gap and
push the catches
downwards
Hole
Front panel
Flat panel
chapter.
Holes for catches
Drain pan projection
portion for catches
Catches on lower
side of front panel
Guide at
front panel
9