Hitachi RCI-1.0FSN4 Service Manual page 75

2 Unit installation
RPK - FSN(H)3M Wall mounted

Removal of the front panel for RPK-(2.0-4.0)FSN3M
Hold both sides of flat panel and open it fully.
Lift up the air filter, detach the catches from the indoor unit and remove the air filter downward.
After the right arm shaft is pushed inward and the shafts are removed from the front panel, pull the flat panel frontward
while the right arm shaft is slightly pushed inward.

Attaching flat panel for RPK-(2.0-4.0)FSN3M
Insert completely the left and right arm shafts of flat panel
into the holes along the guide at the front panel. After the
flat panel is attached completely, insert the catches for air
filter to fix.
!
C A U T I O N
When removing front panel, do not apply an excessive force by
hitting, etc. It may break the unit body.
61 SMGB0099 rev.0 - 12/2016
Push the shaft
toward arrow
direction.
Flat panel
Flat panel
Remove this part
from the hole.
Hole
front panel
Front panel
2
Guide at