Table of Contents
Advertisement
PLACING A CALL
Placing/ending a call
When line is busy and you cannot get through.
You will hear the busy tone. (Sometimes a display saying the line is busy or an announce
saying something like the phone is either switched off or out of the service area.)
MEMO
• You can dial after pressing
is placed.
• To check a number of 13 or more digits, press and hold down
release
, it will go back to displaying the last 12 digits.
• The calling time that is displayed is a guide. It may not match your phone bill.
• The dialed phone number is kept in the redial (page 30).
• By pressing
easier to see.
1
1
Pull out the antenna.
2
Dial the phone number of the party you wish to call.
Always include the local area code when dialing.
You can enter up to 32 digits but in double-size
digit display, you can only display 12 digits at any
one time. When 13 or more digits are entered,
you can press and hold
Fixing mistakes
3
Clear the last digit : Press
Clear all
for more than a second, or press
4
3
Press
lights up and when the recipient answers, you
can communicate. The calling time is displayed.
2
4
Press
disappears and the call duration is displayed for 3
seconds. Then the phone returns to standby screen.
. If you do this, there will be a 5 second delay after dialing before the call
, you can enter " " to split up the phone number so that it is
to display all digits.
.
: Press and hold down
.
to terminate your call.
. When you
07031234567
.
00:01
0703123456712345
6789012345678901
29
Advertisement
Table of Contents
