Table of Contents
Advertisement
Operation for transmitting side
Press
d
Press
d
Press
d
Input the password number (4 digits)
The password number is the same
one inputted at the receiving side.
d
Press
When the UTS-708J sends the
signal, it is displayed from
"Sending..." to "
You can press
Memo
• The transceiver number for the
transmitting side UTS-708J is set to
"0".
• The password must be muched with
the receiving and transmitting both
sides.
Operation for clearing group
registration
Press
d
Press
d
Sent".
instead of
.
Point
to "YES" by using
To cancel the clearing, point
"NO".
d
Press
The transceiver registration is
cleared.
Calling the other party
Operation
Pull out the antenna
d
Input the transceiver number of
the party you wish to call
d
Press
lights up and when the recipient
answers, the calling time is
displayed.
d
Communicate to the other party
lights
d
Press
to terminate your call
The display of signal condition
It will display signal condition during a call
only, not during standby condition.
If out of service area tone sounds
More to the area where you can get
stronger signal within 30 seconds.
to
105
Advertisement
Table of Contents
