Charging The Battery Pack; Loading And Removing The Battery Pack - UTStarcom UTS-708J Instruction Manual

Personal station (ps)
Table of Contents

Advertisement

CHARGING THE BATTERY PACK

Loading and removing the battery pack

Loading the battery pack
1
Connect the battery pack's connector.
Do not misconnect the connectors
direction and put it in firmly.
2
Put battery pack in.
Do not slacken the cord and put it into the
guide gap in the compartment firmly.
3
Attach the battery compartment cover.
Close the cover firmly. If the cover is
not closed completely, water can get in
or cover can open by vibration and it
may cause the battery to fall out.
(1) Place the battery compartment cover parallel to the phone in the position
shown in the right figure.
(2) While keeping a finger on the center of the cover, push the bottom part into
the phone until you hear a click.
(3) Ensure that there is no gap between the cover and the phone's body.
Removing the battery pack
When replacing the battery pack, you must remove the battery pack.
The battery pack is a consumable. Depending on how frequently it is used, it will last for
about one year. When charging the battery pack for more than 4 hours results in only
a few minutes of battery power, it is time to replace it with a new battery pack (sold
separately). Contact your dealer for purchasing information.
Always handle the battery pack correctly. Otherwise, it could cause leakage,
heat generation or explosion. Always follow these instructions.
• Do not short circuit the + and - terminals.
• Do not throw into fire or heat it.
• Do not disassemble or modify it.
22
Caution
Danger
Red
Black

Advertisement

Table of Contents
loading

Table of Contents