Receiving Data By 32Kbps High Speed Data Transfer - UTStarcom UTS-708J Instruction Manual

USING THE 32KBPS HIGH SPEED DATA TRANSFER SERVICE (cont)

Receiving data by 32kbps high speed data transfer

When receiving 32kbps high speed data transfer calls, follow the instructions of
"Preparing for 32kbps high speed data transfer" (page 84) beforehand.
1
When a 32kbps high speed data transfer call is
received, the ring-tone rings, the incoming light blinks
and the display changes to incoming call condition.
The call is differentiated from a normal voice call by "
displayed.
When 32kbps high speed data transfer is sent from PHS or
ISDN etc, the caller's phone number may be displayed.
2
32kbps high speed data transfer connection is
performed by PC etc.
3
When terminating the 32kbps high speed data transfer, use the PC
etc. to perform the operations to terminate the data transfer.
Also, if you press
MEMO
• When a 32kbps data card is not connected and a 32kbps high speed data transfer
call is received, the call cannot be received and 32kbps high speed data transfer
cannot be performed. In such cases, the ring-tone does not ring and the incoming
light does not blink.
• When receiving a 32kbps high speed data transfer call, you cannot receive the call
by using
• Sometimes transfer cannot operate correctly while moving or while in places of
weak signal or places where the signal condition is bad. Use in places with a good
signal condition.
86
on this phone, you can terminate the data transfer.
.
Incoming
07031234567
" being
Data communication
00:05