Charging; Turning Power On - UTStarcom UTS-708J Instruction Manual

CHARGING THE BATTERY PACK (cont.)

Charging

Insert the phone into the battery charger.
The charging LED will turn on.
Charging LED display
While charging: Charging LED is red
Charging is completed: Charging LED is green
Charging time
Maximum charging time approximately 4 hours
Keep charging until the charging LED changes from red to green.
MEMO
• You can charge the phone whether the power is on or off.
• It is recommended that you always insert the phone into the battery charger when you
are not using it. Excess charging will not cause any harm. (Parts of the phone and battery
charger may get warm but this is caused by the charging and does not cause any harm.)
• When using for the first time, and when the battery pack has been replaced, charge until the
charging LED turns green. When you purchase the battery pack, it will not be sufficiently charged.
• If after charging is completed, you remove the phone and then immediately return
the phone to the battery charger, the charging LED will be red. This is normal.
• Do not insert the phone into the battery charger in wrong direction. Charging will not be possible.
• Phone and battery charger get warm while charging. This is normal.
• When the battery remaining power display becomes
• If the charging terminals get dirty, the charging LED may not light up red. Clean the
terminals occasionally by wiping with a dry cloth.

Turning power on

Press and hold
2 seconds.
Your phone number appears for about
5 seconds.
Turning power off
Press and hold
24
for more than
for more than 2 seconds.
, always charge the battery.
Public Mode
07021234567