Table of Contents
Advertisement
USING PHONE AS A TRANSCEIVER
Things to check before using
If you use the UTS-708J as a transceiver,
you must register multiple UTS-708J
phones at the site as a transceiver group.
Switching modes
When using the phone as a transceiver
switch to transceiver mode by following
the instructions of "Setting operation
modes (F51)" (page 25).
Transceiver mode:
Dedicated transceiver mode
Transceiver communication range
You can use this phone as a transceiver
while inside a distance of 100 ~ 150m
from the other party.
Also, every 3 minutes the phone
disconnects but after about 3 seconds,
it makes a short beep sound and
reconnects (when connecting (link) sound
(F82) is set to "ON").
104
Registering a transceiver group (F55)
Registration for the transceiver group
needs to operate with receiving and
transmitting both sides.
Operation for receiving side
14:38
Sun 2/20
You can press
Input a password number (4 digits)
"Prepping to Receive..." is displayed.
You can press
displayed from "Receiving..." to
Then, the operation for the receiving
Press
d
Press
d
Press
d
Input a transceiver number
(1 ~ 8191)
d
Press
d
d
Press
When the UTS-708J receives the
signal by transmitting side, it is
"
Receiving Finished".
side UTS-708J is finished.
.
instead of
.
instead of
.
Advertisement
Table of Contents
