Sending Data By 32Kbps High Speed Data Transfer - UTStarcom UTS-708J Instruction Manual

MEMO
• You can use 32kbps high speed data transfer in public mode and transceiver mode.
• After using data transfer, push in the terminal cap so that it locks in the storage
position.
• Even when a cable is connected, the phone can be used as a normal voice phone.

Sending data by 32kbps high speed data transfer

You can perform the 32kbps high speed data transfer from this phone or from a PC etc.
For instructions on 32kbps high speed data transfer, read the instruction booklet for the 32kbps
data card (sold separately).
Before using, follow the instructions of "Preparing for 32kbps high speed data transfer" (page 84).
1
Send 32kbps high speed data transfer from this phone
or a PC etc.
If you send automatically, sending is performed by operation
from the connected PC etc.
If you send manually, you can send by dialing, redialing, or displaying
a number such as a call memory number or phone book number.
When sending, press
2
After connecting, carry out the 32kbps high speed
data transfer by using your PC etc.
3
When you want to terminate the 32kbps high speed data transfer,
perform the operation to terminate the data transfer from the PC etc.
Also, if you press
transfer.
MEMO
• You may not be able to send correctly if you are moving or if the signal is weak or the
signal status is bad. Perform this operation in places where the signal condition is good.
.
of this phone, you can terminate the data
Data
00:05
85