Table of Contents
Advertisement
Chapter 2 Preparations
1.11.6
Removal / Replacement
Remove a DIMM in the following procedure.
1.
See steps 1 to 7 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Open levers of the DIMM socket outward.
The socket is unlocked and DIMM can be
removed.
3.
Pull out the DIMM straight.
4.
Confirm that no error messages are displayed on POST. If any error message is displayed, see Chapter 3
(1. POST Error Message) in "Maintenance Guide".
5.
Run BIOS Setup Utility, select Memory Configuration from the Advanced menu, and then specify Yes
for Memory Retest. After that, select Save Changes and Exit to reboot.
6.
If using a Windows OS, see Chapter 1 (7.1 Specifying Memory Dump Settings (Debug Information)) in
"Installation Guide (Windows)".
For other OS, follow the manual of the OS.
Note
• When removing a defective DIMM, check error messages displayed at POST or
NEC ESMPRO and check the DIMM socket where the defective DIMM is
installed.
• At least one DIMM needs to be installed for the server to operate.
We recommend that the size of paging file be set to the recommended size (total
Tips
memory size x 1.5) or more.
Express5800/R120g-2E User's Guide
1. Installing Internal Optional Devices
65
Advertisement
Table of Contents
