Table of Contents
Advertisement
Chapter 2 Preparations
REAR
12. Make sure that the heat sink is installed on a level with the motherboard.
13. Continue to install or remove internal optional devices, mount and connect the server, and then turn it on.
14. Run BIOS Setup Utility (SETUP) to confirm the following settings. See Chapter 3 (2. BIOS Setup Utility
(SETUP)).
Advanced → Processor Configuration → Processor Information
56
Note
The heat sink must be mounted in the predefined direction. Make sure the direction
of heat sink before mounting it.
The label indicating the mounting orientation of the CPU#2 heat sink is affixed to the
side surface of the heat sink.
•
If the heat sink is not level, remove it, and then install it again.
Note
The following probably causes the heat sink not to be level:
–
The CPU is not positioned correctly.
–
Some screws are not completely tightened.
•
Do not move the secured heat sink.
[CPU ID]
[L2 Cache RAM]
[L3 Cache RAM]
Express5800/R120g-2E User's Guide
1. Installing Internal Optional Devices
FRONT
Advertisement
Table of Contents
