Table of Contents
Advertisement
Chapter 3 Setup
2.
BIOS Setup Utility (SETUP)
This section describes how to configure Basic Input Output System (BIOS).
Make sure you have read and understood this section to configure properly.
2.1
Overview
BIOS Setup Utility (SETUP) is a utility to do basic hardware settings. This utility is installed in a flash memory in
the server as standard and can be run without requiring a media for boot.
BIOS settings were configured with optimal settings before the server was shipped to you. Therefore, in most of
cases, you should not need to use the SETUP. Use only when the case applies to any of cases described in
Chapter 3 (2.4 Cases that Require Configuration).
2.2
Starting SETUP Utility
Run POST following Chapter 3 (1.1.1 POST sequence).
After a while, the following message will be displayed on the lower left of the screen. (The on-screen message
depends on your environment.)
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
If you press the <F2> key, SETUP starts upon completion of POST, and the Main menu is displayed.
Password
If you have set a password, a message prompt you to enter password will be displayed.
Enter password [
You can attempt password entry up to 3 times. If you entered an incorrect password 3 times, operation stops.
(You cannot operate further.) Turn off the power.
Saving changes
If you finish configuration, select Save & Exit and then Save Changes and Exit to save changes and exit.
If you wish to exit without saving the changed parameters, select Save & Exit
and Exit.
158
In Legacy boot mode, you can also launch SETUP by pressing the <F2> key while
Tips
expanding option ROM.
Tips
•
If you wish to restore the setting to default values, select Save & Exit and then Load
Setup Defaults.
•
The default value might be different from the factory setting.
•
You cannot restore the default value in the following submenus in Advanced menu:
– iSCSI Configuration submenu
– UEFI Driver Configuration submenu
Express5800/R120g-2E User's Guide
]
2. BIOS Setup Utility (SETUP)
Discard Changes
and then
Advertisement
Table of Contents
