Exit Delay Restart; Silent Control In Away Mode; Quick Exit In Away Mode; Auto Stay Mode - 2gig Technologies GO!CONTROL User Manual

Go!Control Wireless Security System | User Guide
When arming the system in
Away Mode, an Entry Delay
check box is shown on the
Arming Screen. By default,
this option is checked, so the
programmed delay doors allow time for
disarming the system after the door is
opened. If you un‐check this box, the
delayed alarm trigger is removed from all
sensor‐protected doors programmed for
delay. Those entrances instantly trigger an
alarm if they are opened in Away Mode.
NOTE: With the Entry Delay disabled, you
must remotely disarm the system with a
wireless key fob before entering.

Exit Delay Restart

The Exit Delay Restart option extends the
Exit Delay one time if you need to re‐enter
the premises. With the Exit Delay Restart
option, when you re‐enter the premises
after you have left, but before the Exit Delay
timer expires, will restart the Exit Delay
timer, giving you the full length of time to
leave again.
TIP: The Exit Delay Restart option only works
once, each time the system is armed.

Silent Control in Away Mode

Three options for silencing the beeps and
announcements are available when arming
or disarming the system in Away Mode.
• On the Control Panel's Home and
Security Screens, a Silent Control button
is displayed.
• On the Arming Screen, a Silent Exit
check box is displayed.
• On the Exit Delay Screen, a Silence
button is displayed.
Selecting any of these options silences the
Control Panel beeps and announcements,
and when arming, selecting Silent Control
doubles the length of the Exit Delay.

Quick Exit in Away Mode

A programmable option called Quick Exit
may be displayed on the Security Screen
while the system is armed in the Away
Mode. Pressing the Quick Exit button starts a
13 ©2013 2GIG Technologies Inc. All Rights Reserved.
timer to allow someone to exit or enter
through a sensor‐protected door
programmed for delay without having to
disarm the entire system. When the delay
timer runs out, the system returns to the
normal Away Mode.
TIP: If interior sensors are installed in the
system in certain areas, do not violate
those sensors when using the Quick Exit
feature in Away Mode.

Auto Stay Mode

The system may have been programmed by
the installer for Auto Stay Mode. If this
option is on and the system is armed in Away
Mode, if an exit/entry delay sensor is not
triggered before the Exit Delay expires (no
one left the premises), the system
automatically arms in Stay Mode instead of
Away Mode.
NOTE: Quick options can be turned on or off
by your installer. Refer to "Installer
Programmed Options" on page 38, to see
which options have been set for your
system.
Arming to Away Mode
Use the Away Mode to arm the system when
everyone will be leaving the home. The
Away Mode normally has an Entry Delay so
someone with a User Code can re‐enter
without causing an alarm. Interior and
perimeter sensors are armed in the Away
Mode.
Close all sensor‐protected doors and
1
windows before arming.
Verify that the
2
Panel is lit green, indicating that the
system is ready to arm. The Security
button on the Control