Disarmingthe System - 2gig Technologies GO!CONTROL User Manual

button and Arm button on the display
will also be green when all perimeter
sensors are closed. If the
displayed on the status bar, an interior
sensor is open, be sure to close or
manually bypass the interior sensors or
an alarm will occur.
To arm the system quietly without
3
sounding any announcements, press the
button before performing the next
steps:
• From the Arming screen select the
Silent Exit check box
Or
• During the Exit Delay, press Silence
From the Security Screen, or the Menu
4
Screen, press Arm.
If there are any open perimeter door or
window sensors, the Bypass Screen
appears. Close all the sensors displayed
or press Bypass All to force bypass the
displayed sensors.
NOTE: Bypassed sensors do not trigger an
alarm.
To bypass sensors, enter a User Code
unless the installer has set the system for
Quick Bypass.
On the Arming Screen, the Entry Delay
5
check box option can be used with Away
Mode.
• The system can be armed without an
Entry Delay. All perimeter doors trigger
the alarm instantly. The system has to be
disarmed with a wireless key fob. To arm
with all exit/entry perimeter doors as
instant, un‐check the Entry Delay option
button.
Press Away.
6
To arm the system, enter a User Code if
your installer has turned off the system's
Quick Arming feature.
The system arms and shows the Exit
7
Delay counting down. When the Exit
Delay expires, the system is fully armed
in the Away Mode.
NOTE: When the system is armed in the
icon is
DISARMING THE SYSTEM
To stop the Control Panel from triggering
burglary alarms, the system needs to be
disarmed. Disarming turns off the burglary
detection part of the system for sensors that
are not 24‐hour sensors. Disarming also
stops any type of alarm in process.
Disarm the system from Stay Mode before
exiting the premises. The system should be
disarmed from Away Mode before or while
entering the premises. When disarming from
the Control Panel or wireless keypad, enter a
valid User Code. A wireless key fob can also
be used to disarm the system. Entering a
User Code is not required when disarming
with a wireless key fob.
An important feature of the Control Panel is
its ability to warn you if an alarm has
occurred while you were away. If an alarm
was triggered while the system was armed,
the alarm siren runs for a preset length of
time then stops. When you enter to disarm
the system, instead of sounding the normal
Entry Delay beeps, the Control Panel sounds
repeated fast beeps to warn you that an
alarm has occurred while you were away.
©2013 2GIG Technologies Inc. All Rights Reserved.
Away Mode, beeps sound during the Exit
Delay (faster beeps during the last 10
seconds).
When you enter your home to
disarm the system, if you hear
fast repeated beeps instead of
the normal entry delay beeps,
Use Extreme Caution! An intruder may
still be present inside the building! Wait
outside and use a Cell Phone to call law
enforcement for assistance.
Burglary Protection
14