Installer Programmed Options; Siren Run Time; Sensor Triggerlimit; Fire Horn Run Time - 2gig Technologies GO!CONTROL User Manual

INSTALLER PROGRAMMED OPTIONS

The installer can program different options
to customize the installation. The options
listed below show the default settings and a
check box or area to denote custom settings.

Siren Run Time

If there is a burglary, panic (police), or
emergency alarm, the Control Panel sounds
the siren for a preset time. After the time
expires, the siren will stop sounding.
(Auxiliary alarms run for an unlimited time.)
4 Minutes is the default, or the following:
 8 Minutes
 12 Minutes
 16 Minutes
 Unlimited
Sensor Trigger Limit
The system limits the number of times a
sensor can re‐trigger an alarm while the
system is armed. The setting is 1 to 6 times
per sensor, per arming period.
2 Triggers is the default, or the following:
 1 Trigger
 3 Triggers
 4 Triggers
 5 Triggers
 6 Triggers

Fire Horn Run Time

If there is a fire or carbon monoxide alarm,
the Control Panel sounds the fire alarm horn
for a preset time. After the time expires, the
fire alarm horn will stop sounding.
4 Minutes is the default, or the following:
 8 Minutes
 12 Minutes
 16 Minutes
 Unlimited

Exit Delay

The Exit Delay begins immediately after
arming the system. The delay gives you time
to leave through the designated exit/entry
door without setting off the alarm. During
the Exit Delay beeps sound, and faster beeps
sound during the last 10 seconds.
NOTE: Arming remotely does not start an
Exit Delay.
• 60 Seconds is the default, or ________
For ________ Door

Entry Delay

The Entry Delay begins when the designated
entry/exit door is opened while the system is
armed. The delay gives you time to disarm
the system before triggering the alarm. You
must enter a User Code on the Control Panel
or Wireless Keypad before the Entry Delay
time expires. During the Entry Delay, beeps
sound to remind you to disarm the system.
The system supports two different Entry
Delays:
• Entry Delay #1 is for your primary
entrance door
• 30 Seconds is the default, or _________
For ________ Door
Entry Delay #2 is for a secondary entrance
(such as a garage door) and is usually set
longer to give you time to get to the keypad
and disarm the system.
• 45 Seconds is the default, or _________
For ________ Door
24-Hour Emergency Functions
Three 24‐hour emergency functions: You can
activate the Panic, Fire, and Emergency
buttons on the Control Panel. The installer
can set which emergency buttons on the
Control Panel are active.
 Panic (Audible)
 Panic (Silent)
 Fire
 Emergency
©2013 2GIG Technologies Inc. All Rights Reserved. 38