Key Fob Arm/Disarm Sound; Key Fob Disarm After Alarm Sound; Exit Delay Restart; Cancel Time - 2gig Technologies GO!control 2GIG-CNTRL2 Operation And User's Manual

Installer Set Options

Key Fob Arm/Disarm Sound

The system can be set so when it's armed or disarmed by a wireless key fob, a beep will sound
through the internal and external sounders to indicate that the key fob's signal was received. This
helps in installations where the Control Panel is not visible or there are no other system status
indications at the key fob's location.

Key Fob Disarm After Alarm Sound

The system can be set so when it's disarmed with a wireless key fob after an alarm has occurred, a
special series of beeps will sound through the internal and external sounders. This option serves as a
safety alert to warn you to approach the premises with caution as an intruder may still be present.
★ IMPORTANT: If you return to the premises and hear the special beeps when disarming
with the key fob, USE CAUTION! The special beeps indicate that an alarm has occurred
while you were gone. AN INTRUDER MAY STILL BE ON THE PREMISES. LEAVE
IMMEDIATELY AND CONTACT THE POLICE FROM A SAFE LOCATION.

Exit Delay Restart

The Exit Delay Restart option will extend the Exit Delay one time if you need to re-enter the premises.
When the system is armed in the Away Mode, the Exit Delay gives you time to leave without setting
off the alarm. With the Exit Delay Restart option, re-entering the premises after you have left, but
before the Exit Delay timer expires, will restart the Exit Delay timer, giving you the full length of
time to leave again. The restart option only works once, each time the system is armed.

Cancel Time

To limit responses to false alarms, a "cancel" message will be sent to the Central Monitoring Station
if the system is disarmed within a preset period of time after an alarm is triggered. The alarm report
is always sent, but it will be followed by a cancel report if you disarm the system within the preset
time.
This option helps the Central Monitoring Station to determine whether you accidently caused the
alarm or if the alarm report was caused by an intruder. It also lets the Central Station know that you
have returned to the premises. Even if a cancel message is sent, the Central Station will verify the
alarm and possibly dispatch help. The cancel message may be processed by the Central Station at a
later time depending on system programming.
❑ 5 Minutes (regular setting)
40
KEY FOB ARM/DISARM SOUND
❑ OFF (regular setting)
KEY FOB DISARM AFTER ALARM
SOUND
❑ OFF (regular setting)
EXIT DELAY RESTART
❑ ON (regular setting)
CANCEL TIME
❑ ON
❑ ON
❑ OFF
_________ Minutes