Alarm Dialing Equipment; Wireless Product Notice - 2gig Technologies GO!CONTROL User Manual

Alarm Dialing Equipment

If your home has specially wired alarm
equipment connected to the telephone line,
ensure that the installation of any other non‐
alarm devices does not disable your alarm
equipment. If you have questions about
what will disable alarm equipment, consult
your telephone company or a qualified
installer.
IMPORTANT: When programming
emergency numbers or making test calls
to emergency numbers remember the
following:
Remain on the line and briefly explain to
1
the dispatcher the reason for the call.
Perform such activities in the off‐peak
2
hours, such as early mornings or later
evenings.
Follow the central station operator's
3
instructions for updated dialer
programming, if re‐programming of the
dialer is required.
Alarm dialing equipment must be able to
seize the telephone line and place a call in an
emergency situation. It must be able to do
this even if other equipment (telephone(s),
answering system, computer modem, etc.)
already has the telephone line in use. To do
so, alarm dialing equipment must be
connected to a properly installed RJ31X that
is electrically in series with and ahead of all
other equipment attached to the same
telephone line. Proper installation is
depicted in the figure on the previous page.
If you have any questions concerning these
instructions, you should consult your
telephone company or a qualified installer
about installing the RJ31X jack and alarm
dialing equipment for you.
Alarm Installation Notes to
Installer
For products equipped with an RJ31X jack
the line seize feature shall be verified. Be
certain the local telephone and incoming
line connections are not reversed. These
lines are not reversed if the alarm dialer can
communicate with the central station.
New Services Notes to User
The installation and/or monitoring company
shall be notified if new telephone service,
e.g. DSL, is installed.
WIRELESS PRODUCT
NOTICE
Radio controls provide a reliable
communications link and fill an important
need in portable wireless signaling; however,
there are some limitations which must be
observed.
For U.S. installations only: The radios are
required to comply with FCC Rules and
Regulations as Part 15 devices. As such, they
have limited transmitter power and
therefore limited range.
A receiver cannot respond to more than one
transmitted signal at a time and may be
©2013 2GIG Technologies Inc. All Rights Reserved.
Regulatory Information
45