Burglary Protection; Sample Floor Plan - 2gig Technologies GO!CONTROL User Manual

BURGLARY PROTECTION

When your system was setup by your installer, wireless sensors were placed to monitor
specific doors and windows. The installer selected these doors and windows as likely places
where an unlawful intrusion might occur and could be detected. Each sensor was
programmed to have the system react in a specific way. See "Installer Programmed Options"
on page 38 for specifics about each sensor.
Some sensor types such as smoke detectors, carbon monoxide detectors, panic buttons, etc.
are always active and can trigger an alarm at any time. Other sensors on protected doors and
windows are part of the burglary protection part of the system, and can be turned on or off.
Turning on the burglary protection part of the security system is called "Arming the System".
The burglary protection part of the system can be armed in two modes: Stay Mode or Away
Mode.

SAMPLE FLOOR PLAN

Refer to the floor plan below. It shows a typical residential installation and the various types of
wireless sensors and their functions.
A Front and side door sensors have Exit/Entry delay
B Side and main garage door sensors have Exit/Entry delay
CP Control panel
DW Door/window sensor
PIR Motion detector
This security system is in compliance with UL 681 (Burglar and Holdup Alarm
NOTE:
Systems) and UL 827 (Central Station Alarm Services).
©2013 2GIG Technologies Inc. All Rights Reserved.
SMKE Smoke detector
CO Carbon monoxide detector
GB Glass break sensor
PAD Wireless keypad
ES External siren
7