Key Fob Auxiliary; Wireless Keypadarmingand Disarming; Wireless Keypadarmingto Stay Mode; Wireless Keypadarmingto Away Mode - 2gig Technologies GO!CONTROL User Manual

Go!Control Wireless Security System | User Guide
NOTE: If an emergency alarm is triggered by
a key fob, it cannot be stopped using the
key fob Disarm button. The alarm must
be canceled at the Control Panel.

Key Fob Auxiliary

• To trigger the Control Panel's auxiliary
output, press the Auxiliary button.
If you use the Auxiliary button, the auxiliary
output controls the _________________...
WIRELESS KEYPAD
ARMING AND DISARMING
Your system may be equipped with one or
more wireless keypads. Up to four wireless
keypads can be used to control the system
remotely from the main Control Panel.
Two types of wireless keypads are available.
A wireless keypad without a screen, and the
wireless touch screen keypad.
The wireless touch screen keypad operates
virtually the same as the Control Panel. Each
standard wireless keypad has buttons for
entering User Codes, Stay and Away mode
buttons, and Fire and Police emergency
buttons.
Check the Installer Set Options section in this
guide to verify which 24‐hour Fire and Police
emergency buttons have been enabled by
the installer.
Wireless Keypad Arming to
Stay Mode
To arm the system to Stay Mode using a
1
wireless keypad, enter a User Code.
Press the Stay button.
2
If Quick Arming has been programmed
3
by your installer, just press the Stay
button.
If there are open perimeter doors or
windows, the system does not allow Arming
to Stay Mode with a wireless keypad. All
open sensors must be bypassed at the
Control Panel first.
17 ©2013 2GIG Technologies Inc. All Rights Reserved.
WIRELESS KEYPAD
ARMING TO AWAY MODE
To arm the system to Away Mode using a
1
wireless keypad, enter a User Code.
Press the Away button.
2
If Quick Arming has been programmed
3
by your installer, just press the Away
button
NOTE: If there are open perimeter doors or
windows, the system does not allow
Arming to Away Mode with a wireless
keypad. All open sensor‐protected doors
and windows must either be closed or
bypassed at the Control Panel before
arming with a wireless keypad.
Wireless Keypad Disarming
• To disarm the system from Stay or Away
mode, enter a User Code.
Wireless Keypad Fire Emergency
• To trigger a emergency fire alarm using a
wireless keypad, press the Fire button
for 2 seconds.
NOTE: To use wireless keypad to trigger a
fire alarm, this option must already be
enabled by your installer.
Wireless Keypad Police
Emergency
• To trigger a emergency police alarm
using a wireless keypad, press the Police
button for 2 seconds.
NOTE: To use wireless keypad to trigger a
police alarm, this option must already be
enabled by your installer.