Inspur NF5180M4 User Manual page 7

7. Please place the system far away from the cooling plate and at the place with heat
sources, and be sure not to block the air vents.
8. Be sure not to scatter food or liquid in the system or on other components, and do not
use the product in humid and dusty environment.
9. CAUTION: Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of
Used Batteries According to the Instructions.
ATTENTION: risque d'explosion si la batterie est remplacée par un type incorrect. Jetez
les piles usagées selon les instructions.
The replacement of batteries with those of incorrect model may cause explosion. When
replacement of batteries is required, please consult first the manufacturer and choose
batteries of the same or a similar model recommended by the manufacturer. Do not
dismount, extrude and pink the batteries or make the external connection point short
circuit, and do not expose them in the environment over 60°C. Never throw them into
fire or water. Please do not try to open or repair the batteries, and be sure to reasonably
deal with the flat batteries and do not put the fl at batteries, the circuit boards that may
include the batteries and other components with other wastes. For relevant battery
recovery, please contact the local waste recovery and treatment mechanism.
10. Before installing equipment in the chassis, please install front and side supporting feet
on the independent chassis; for cabinet connecting with other chassis, it shall install
the front supporting foot first. If you fail to install correspondingly the supporting foot
before installing equipment in the chassis, it may cause the cabinet to turn over in some
cases, and thus may cause personal injury. Therefore, it is necessary to install supporting
feet before installing equipment in the chassis. After installing the equipment and other
components in the chassis, it can only pull out one component from the cabinet through
its sliding component at one time. Pulling out several components at the same time may
lead the cabinet to turn over and cause serious personal injury.
11. Please do not move the chassis independently. Considering the height and weight of the
chassis, at least two people are needed to complete its movement.
12. Please do not carry out direct contact operation on power copper busbar when the
cabinet is powered on, and it is prohibited to carry out direct short circuit of power
copper busbar.
13. The product is Grade A product, and in the living environment, it may cause radio
interference. In such case, it may need the user to take feasible measures for the interference.
２