Alcatel-Lucent 7450 System Management Manual page 142

Management Access Filter Commands
When the source interface is configured, only management traffic arriving on those ports satisfy the
match criteria.
The no form of the command reverts to the default value.
Default any interface
Parameters port-id — The port ID in the following format: slot[/mda]/port.
cpm — Configure the Ethernet port on the primary
src-ip
Syntax [no] src-ip {[ip-prefix/mask] | [ip-prefix] | ip-prefix-list prefix-list-name}
Context config>system>security>mgmt-access-filter>ip-filter>entry
Description
This command configures a source IP address range prefix to be used as a management access filter
match criterion.
The no form of the command removes the source IP address match criterion.
Default No source IP match criterion is specified.
Parameters ip-prefix'mask — The IP prefix for the IP match criterion in dotted decimal notation.
ip-prefix-list — Creates a list of IPv4 prefixes for match criteria in IPv4 ACL and CPM filter
ip-prefix-list-name — A string of up to 32 characters of printable ASCII characters. If special charac-
ters are used, the string must be enclosed within double quotes.
mask — Specifies the subnet mask length expressed as a decimal integer.
Page 142
For example: To configure port 3 on MDA 2 on card 1 would be specified as 1/2/3.
Values port-id
encap-val
ccag-idccag-id. path-id[cc-type]
lag-id
cpm
policies.
Values
1 — 32 (mask length), 0.0.0.0 — 255.255.255.255 (dotted decimal)
slot/mda/port[.channel]
0 for null
0 — 4094 for dot1q
ccag keyword
id 1 — 8
path-id a, b
cc-type .sap-net, .net-sap
cc-id 0 — 4094
lag-id
lag keyword
id 1 — 800
keyword
CPMCPMCFM
7450 ESS System Mangement Guide
to match the criteria.