Show Commands
Version
Community
Sec. Level
Replay
Replay from : n/a
Last replay : never
-------------------------------------------------------------------------------
Name
Address
Port
Version
Community
Sec. Level
Replay
Replay from : n/a
Last replay : never
===============================================================================
A:SetupCLI>config>log>snmp-trap-group#
syslog
Syntax
syslog [syslog-id]
Context
show>log
Description
This command displays syslog event log destination summary information or detailed information on
a specific syslog destination.
Parameters
syslog-id — Displays detailed information on the specified syslog event log destination.
Output
Syslog Event Log Destination Summary Output — The following table describes the syslog
output fields.
Page 542
: v2c
: ntttesting
: none
: disabled
: test2
: 20.20.20.5
: 162
: v2c
: ntttesting
: none
: disabled
Values
1 — 10
Table 53: Show Log Syslog Output Fields
Label
Syslog ID
IP Address
Port
Facility
Severity Level
Below Level
Dropped
The syslog ID number for the syslog destination.
The IP address of the syslog target host.
The configured UDP port number used when sending syslog messages.
The facility code for messages sent to the syslog target host.
The syslog message severity level threshold.
A count of messages not sent to the syslog collector target because the
severity level of the message was above the configured severity. The
higher the level, the lower the severity.
7450 ESS System Mangement Guide
Description