Alcatel-Lucent 7450 System Management Manual page 201

Description
dscp
Syntax dscp dscp-name
no dscp
Context config>sys>sec>cpm>ip-filter>entry>match
config>sys>sec>cpm>mac-filter>entry>match
Description
This command configures a DiffServ Code Point (DSCP) name to be used as an IP filter match crite-
rion.
The no form of the command removes the DSCP match criterion.
Default no dscp — No dscp match criterion.
Parameters dscp-name — Configures a dscp name that has been previously mapped to a value using the dscp-
dst-ip
Syntax dst-ip ipv6-address/prefix-length
dst-ip ipv6-prefix-list ipv6-prefix-list-name
no dst-ip
Context config>sys>sec>cpm>ip-filter>entry>match
Description This command configures a destination IP address range to be used as an IP filter match criterion.
To match on the destination IP address, specify the address and its associated mask, for example,
10.1.0.0/16. The conventional notation of 10.1.0.0 255.255.0.0 may also be used.
7450 ESS System Mangement Guide
Table 10: IP Protocol Names (Continued)
Protocol Protocol ID
pnni 102
pim 103
vrrp 112
l2tp 115
stp 118
ptp 123
isis 124
crtp 126
crudp 127
name command. The DiffServ code point may only be specified by its name.
Description
PNNI over IP
Protocol Independent Multicast
Virtual Router Redundancy Protocol
Layer Two Tunneling Protocol
Spanning Tree Protocol
Performance Transparency Protocol
ISIS over IPv4
Combat Radio Transport Protocol
Combat Radio User Datagram
Security
Page 201