Oven Light Control; Programming The Oven; Programming The Timer: Cooking Time - BORETTI BPO-90 Operating Instructions Manual

5 sec.!!
The cleaning process takes place at a temperature
of 250°C and lasts one hour. Do not use it for
cooking food!!
The oven light is activated and can be switched off and on
again at any time.
All the self-cleaning panels will perform effectively for thirty
cleaning processes, after this limit the panels must be replaced.
The panels should be cleaned exclusively with tap water and
replacements can be ordered from your specialised dealer.

Oven light control

The light control is active on all the cooking functions and is
independent, meaning that it can be switched on or off to suit
your requirements, when you want!
The oven light is usually kept on throughout the heating time
and then for three minutes after reaching the temperature set.
From then on, the oven light switches off to save power.
To check the cooking, it may be necessary to switch on the
internal light. All you have to do is touch the light symbol:
the light will stay on for three minutes and then switch off
automatically. Naturally you can switch it off immediately by
touching the light symbol again.
Some models are equipped with a door control. This feature
uses sensor technology to detect the position of the door to
control the oven light: the opening of the door is indicated by
a beep and the light comes on. It switches off when the door
is closed again.

Programming the oven

The programming of the oven offers three modes for controlling
the cooking time. They are available with the standard cooking
functions. When the food probe is used, they are deactivated
(see specific chapter).
The functions can be selected in sequence, from left to right,
by touching the clock symbol: every time it is touched, a
symbol lights up in sequence.

Programming the timer: cooking time

Touch the timer symbol once. The relative symbol lights up.
The clock display will replace the indication of the current time:
The dividing dots flash to indicate that it is possible to
programme the cooking time.
Once the cooking time has been set, the
display will show the current time again
and the cooking time symbol will be lit.
The count begins now. When the time is up, the oven will make
a beeping sound, the heating elements will be switched off and
cooking will stop.
The special symbol will flash, as will the duration which was
29
GB