Replacement Of The Oven Light - BORETTI BPON 45 Operating Instructions Manual

EN
4. Slide out the internal glass as shown below. Remove the
second and third panes of glass (middle panes) for cleaning
sliding out the rubber strip.
5. Replace the middle panes after cleaning in reverse order,
checking that they are oriented so the words INTERNAL
SIDE are properly legible.
34
NOTE: a slight gap between the middle panes and the side
supports is normal because it allows for the heat
expansion of the glass.
6. Place the pack of three glass panes between the two uprights
and replace the top strip.

Replacement of the oven light

WARNING
Make sure that:
• The oven and lights are cool and power to the oven has
been turned off before replacing the light bulb(s). Failure
to do so could result in electrical shock or burns.
• The lenses must be in place when using the oven.
• The lenses serve to protect the light bulb from breaking.
• The lenses are made of glass. Handle carefully to avoid
breakage. Broken glass could cause an injury.
3
1
2
(230V - 25W G9)
(230V - 15 or 25W)
2
3
1
1 Turn off power at the main power supply (fuse or breaker
box).
2 Remove the lens (1).
3 Remove the light bulb (2) from its socket (3).
4 Replace the bulb (2) with a new one. Avoid touching the
bulb with fingers, as oils from hands can damage the bulb
when it becomes hot.
5 Use one with the same Volt and Watt (see figure).
6 Screw the lens (1) back on.
7 Turn power back on at the main power supply (fuse or
breaker box).
1
2
(230V - 25W G9)