Ipv6 Static Route Settings - D-Link xStack DGS-3600 User Manual

Parameter
IP Address
Subnet Mask
Gateway
Metric (1-65535)
Backup State
Click Apply to implement changes made.

IPv6 Static Route Settings

A static entry of an IPv6 address can be entered into the Switch's routing table for IPv6 formatted addresses. To view the
following window, click Layer 3 > Routing Table > IPv6 Static Route Settings.
This window shows the following values:
Parameter
IPv6 Address/Netmask
Gateway
Metric (1-65535)
Protocol
Delete
To enter an IPv6 Interface into the IPv6 Static Route list, click the Add button, revealing the following window to configure.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Description
Allows the entry of an IP address that will be a static entry into the Switch's Routing Table.
Allows the entry of a subnet mask corresponding to the IP address above.
Allows the entry of an IP address of a gateway for the IP address above.
Allows the entry of a routing protocol metric representing the number of routers between the
Switch and the IP address above.
The user may choose between Primary and Backup. If the Primary Static/Default Route fails,
the Backup Route will support the entry. Please take note that the Primary and Backup entries
cannot have the same Gateway.
Figure 8- 19. IPv6 Static Route Settings window
Description
The IPv6 address and corresponding Subnet Mask of the IPv6 static route entry.
The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
The metric of the IPv6 interface entered into the table representing the number of routers
between the Switch and the IPv6 address above. Metric values allowed are between 1-
65535.
Represents the status (default or static) for the IPv6 routing table entry.
Click the button if you would like to delete this entry from the list.
Figure 8- 20. Static/Default Route Settings – Add menu
123