Snmp Traps Settings; Snmp User Table - D-Link xStack DGS-3600 User Manual

SNMP Traps Settings

The following window is used to enable and disable trap settings for the SNMP function on the Switch. To view this window for
configuration, click Administration > SNMP Manager > SNMP Trap Settings:
To enable or disable the Traps State and/or the Authenticate Traps State, use the corresponding pull-down menu to change and
click Apply.

SNMP User Table

The SNMP User Table displays all of the SNMP User's currently configured on the Switch.
In the SNMP Manager folder, located in the Administration folder, click on the SNMP User Table link. This will open the
SNMP User Table window, as shown below.
To delete an existing SNMP User Table entry, click the
delete.
To display the detailed entry for a given user, click on the View button under the Display heading. This will open the SNMP User
Table Display window, as shown below.
The following parameters are displayed:
Parameter
User Name
Group Name
SNMP Version
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 6- 25. SNMP Trap Settings
Figure 6- 26. SNMP User Table window
Figure 6- 27. SNMP User Table Display window
Description
An alphanumeric string of up to 32 characters. This is used to identify the SNMP users.
This name is used to specify the SNMP group created can request SNMP messages.
V1 - Indicates that SNMP version 1 is in use.
V2 - Indicates that SNMP version 2 is in use.
V3 - Indicates that SNMP version 3 is in use.
below the Delete heading corresponding to the entry you wish to
49