D-Link xStack DGS-3600 User Manual page 97

User Defined
Packet ID
Encap
Port Settings - Allows an individual port to be specified as member of a VLAN.
Tag
None
Egress
Forbidden
Click Apply to implement changes made.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
vines - Using this parameter will instruct the Switch to forward packets to this VLAN if the tag
in the packet header is concurrent with this protocol. This packet header information is defined
by the Banyan Virtual Integrated Network Service (VINES) Protocol.
ipV6 - Using this parameter will instruct the Switch to forward packets to this VLAN if the tag in
the packet header is concurrent with this protocol. This packet header information is defined
by the Internet Protocol Version 6 (IPv6) Protocol.
userDefined - Using this parameter will instruct the Switch to forward packets to this VLAN if
the tag in the packet header is concurrent with this protocol defined by the user. This packet
header information is defined by entering the following information:
Specifies that the VLAN will only accept packets with this hexadecimal 802.1Q Ethernet type
value in the packet header. The user may define an entry, in the hexadecimal form (ffff) to
define the packet identification. (The user only need enter the final four integers of the
hexadecimal format to define the packet ID – {hex 0x0 0xffff}) This field is only operable if
userDefined is selected in the Protocol ID field.
Specifies that the Switch will examine the octet of the packet header referring to one of the
protocols listed (Ethernet, LLC or SNAP), looking for a match of the hexadecimal value
previously entered. all will instruct the Switch to examine the total packet header. After a
match is found, the Switch will forward the packet to this VLAN. This field is only operable if
userDefined is selected in the Protocol ID field.
Specifies the port as either 802.1Q tagging or 802.1Q untagged. Checking the box will desig-
nate the port as Tagged.
Allows an individual port to be specified as a non-VLAN member.
Select this to specify the port as a static member of the VLAN. Egress member ports are ports
that will be transmitting traffic for the VLAN. These ports can be either tagged or untagged.
Select this to specify the port as not being a member of the VLAN and that the port is
forbidden from becoming a member of the VLAN dynamically.
81