Routing Table; Static/Default Ip Route Settings - D-Link xStack DGS-3600 User Manual

Routing Table

The Switch supports static routing for IP and IPv6 formatted addressing. Access both menus in the Routing Table folder.

Static/Default IP Route Settings

Entries into the Switch's forwarding table can be made using both MAC addresses and IP addresses. Static IP forwarding is
accomplished by the entry of an IP address into the Switch's Static IP Routing Table. To view the following window, click
Layer 3 > Routing Table > Static/Default Route Settings.
This window shows the following values:
Parameter Description
IP Address The IP address of the Static/Default Route.
Subnet Mask The corresponding Subnet Mask of the IP address entered into the table.
Gateway The corresponding Gateway of the IP address entered into the table.
Metric Represents the metric value of the IP interface entered into the table. This field may read a
number between 1-65535.
Protocol Represents the protocol used for the Routing Table entry of the IP interface.
Backup State Represents the Backup state that this IP interface is configured for. This field may read Primary
or Backup.
Delete Click the
table.
To enter an IP Interface into the Switch's Static/Default Route Settings window, click the Add button, revealing the following
window to configure.
The following fields can be set:
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Figure 8- 17. Static/Default Route Settings window
button if you would like to delete this entry from the Static/Default Route Settings
Figure 8- 18. Static/Default Route Settings – Add window
122