Rps Installation - D-Link xStack DGS-3600 User Manual

RPS Installation

Follow the instructions below to connect an RPS power supply to the Switch (DPS-500). The DPS-500 is a redundant power-
supply unit designed to conform to the voltage requirements of the switches being supported. DPS-500 can be installed into the
DPS-900, or DPS-800.
CAUTION:
with installation of the DPS-500.
CAUTION: Installing systems in a rack without the front and side stabilizers installed could cause the
rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always
install the stabilizers before installing components in the rack. After installing components in a rack, do
not pull more than one component out of the rack on its slide assemblies at one time. The weight of
more than one extended component could cause the rack to tip over and may result in injury.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
The AC power cord for the Switch should be disconnected before proceeding
Figure 2 - 4. Installing the DPS-500
11