Diagnosing and Troubleshooting
Notes:
• Many of the parameters referenced and techniques described here require a good
understanding of ultrasonic technologies and Siemens echo processing software. Use
this information with caution.
• If the setup becomes too confusing do a
• As a further resource,
website. Go to www.siemens.com/level.
Communication Troubleshooting
Generally
1.
Check the following:
•
There is power at the device
•
The optional LCD is showing the relevant data
•
The device can be programmed using the local push buttons.
•
If any fault codes are being displayed, see "General Fault Codes" on page 233
for a detailed list.
2.
Verify that the wiring connections are correct.
Specifically
1.
The SITRANS LUT400 is set to communicate via a HART modem but no
communication is returning to the master.
•
Check that the device address is set correctly for the HART network.
2.
A SITRANS LUT400 parameter is set via remote communications, but the parameter
remains unchanged.
•
Try setting the parameter from the local push buttons. If it can not be set using
the buttons, ensure
If you continue to experience problems, go to our website at:
www.siemens.com/sitransLUT400, and check the FAQs for SITRANS LUT400, or contact
your Siemens representative.
A5E33329501
SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
3.2.3. Master Reset
Understanding Ultrasonic Level Measurement
5. 1 . Write Protection
and start again.
is available on our
is set to the unlock value.
Page 231