Communication - Siemens SITRANS LUT400 Operating Instructions Manual

4. Communication

4.1. Device Address
Sets the device address or poll ID on a HART network.
Values
To reset Device Address via SIMATIC PDM:
• Open the project in Process Device Network View then right-click on the
device.
• Go to Object Properties and open the Connection tab to access the field Short
Address.
The following list of parameters are available in PDM. Unless otherwise
Note:
stated, the options are displayed in integer format (as required by HART
communications).
Manufacturer's ID
Read only. Numerical code that refers to the manufacturer of the device (e.g. 42, which
refers to Siemens).
Device Id
Read only. Unique identification of the device by manufacturer and device type.
Product Id
Read only. Unique identification of the product by model number.
Device Revision
Read only. Device revision associated with a specific EDD.
EDD Revision
Read only. Revision of a specific EDD associated with the device.
Universal Command Revision
Read only. Revision of the Universal Device Description associated with the device.
Protocol
Read only. The communication protocol supported by the device.
Common Practice Command Revision
Read only. Revision of the set of HART common practice commands supported by the
device.
A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
Range:
0 to 63 (Set within range of 0 to 15 if HART 5 master used.)
Default: 0
Page 217