Siemens SITRANS LUT400 Operating Instructions Manual page 48

Start of QS
Level Wizard
Select temperature
source
- Temperature Source
- Fixed Temperature
Start of QS Level Wizard
Note:
The introduction screen is displayed only on the device when using the local
push buttons. This screen is not part of the Quick Start when using SIMATIC PDM.
Shows the type of Wizard to be executed.
Options
Transducer
Specifies the Siemens transducer connected to the device.
Options
Operation
Sets the type of measurement (and the corresponding mA output) required for the
application.
distance
Page 40 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
Select transducer
- Transducer
Set level units and
setpoints
- Units
- High Calibration Point
- Low Calibration Point
- Response Rate
CANCEL, START
NO TRANSDUCER, XRS-5, XPS-10, XPS-15, XCT-8, XCT-12, XPS-30, XPS-40,
XLT-30, XLT-60, STH
Default: NO TRANSDUCER
space
level
Select operation
- Operation
Level Wizard
complete
High Calibration Point
Far Range
sensor reference point
Low Calibration Point
7ML1998MV01