Siemens SITRANS LUT400 Operating Instructions Manual page 45

3. Editing in PROGRAM mode
Selecting a listed option
a. Navigate to the desired parameter.
b. Press RIGHT arrow
mode. The current selection is
highlighted.
c. Scroll to a new selection.
d. Press RIGHT arrow
The LCD returns to parameter view and
displays the new selection.
Changing a numeric value
a. Navigate to the desired parameter.
b. When selected, the current value is
displayed.
c. Press RIGHT arrow
mode. The cursor position is highlighted.
d. Use LEFT
move cursor to digit position you wish to
change.
e. As each digit is highlighted (selected),
use the UP
respectively.
f. While decimal point is selected, use UP
position.
g. To escape without saving your changes, press LEFT arrow
is highlighted. Press LEFT arrow
Otherwise, when new parameter value is correct, press RIGHT arrow
continually until OK is highlighted.
h. Press RIGHT arrow
view and displays the new selection. Review for accuracy.
Key functions in Edit mode
Key
A5E33329501 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
to open Edit
to accept it.
to open Edit
and RIGHT arrow
and DOWN arrow
to accept the new value. The LCD returns to parameter
Name
Selecting
options
UP or
DOWN
Alpha-
arrow
numeric
editing
SENSOR
UNITS
menu
SENSOR MODE
name
SENSOR MODE SECONDARY
TRANSDUCER
FREQUENCY
parameter
name
TRANSDUCER
NO TRANSDUCER
XRS-5
XPS 10
XPS 15
XCT 8
XCT 12
XPS 30
CALIBRATION
LOW CALIB. PT.
HIGH CALIB PT
SENSOR OFFSET
parameter
NEAR RANGE
name
FAR RANGE
LOW CALIB. PT.
to
ESC
to increase or decrease the digit
and DOWN arrow
again to escape without saving changes.
Function
Scrolls to item.
- Increments or decrements digits
- Toggles plus and minus sign
2.1.6
parameter
number
XRS 5
current
value
2.1.6
parameter
number
2.2.1
2 00 M
current
value
2.2.1
+ 2 0 M OK
to shift decimal
continually until ESC
Page 37