IBM totalstorage 326 User Reference page 155

Table 27. POST error messages (continued)
Error Meaning
code/Symptom
1600 The Service Processor is not
functioning
1601 The system is able to
communicate to the Service
Processor, but the Service
Processor failed to respond
at the start of POST
1762 Hard-disk-drive configuration
error
178X Hard-disk-drive error
1800 No more hardware interrupts
available for PCI adapter
1962 Drive does not contain a
valid boot sector
5962 IDE CD-ROM configuration
error
8603 Pointing-device error
FRU/action
1. Ensure that a jumper is not installed on J-51
2. Remove the AC power to the system, wait 20 seconds
and then reconnect the AC power. Wait 30 seconds; then,
power-on the appliance.
3. System board
4. Processor/PCI board
Suspected part:
1. Remove the AC power to the system, wait 20 seconds,
and reconnect the AC power. Wait 30 seconds and
power on the system.
2. Flash update the service processor.
3. System board
4. Processor/PCI board
1. Run Configuration/Setup
2. Hard disk cables
3. Hard disk adapter
4. Hard disk drive
5. SCSI backplane
6. System board
1. Run diagnostics
2. Hard disk cables
3. Hard disk adapter
4. Hard disk drive
5. System board
1. Run Configuration/Setup
2. Failing adapter
3. System board
1. Verify that a bootable operating system is installed.
2. Run diagnostics
3. Hard disk drive
4. SCSI backplane
5. Cable
6. System board
1. Run Configuration/Setup
2. CD-ROM drive
3. CD-ROM power cable
4. IDE Cable
5. System board
6. Battery
1. Pointing device
2. System board
Appendix D. Engine POST and diagnostic program messages
143