IBM totalstorage 326 User Reference page 153

Table 27. POST error messages (continued)
Error Meaning
code/Symptom
176 Computer cover or cable
cover was removed without a
key being used
177, 178 Security hardware error
184 Power-on password
corrupted
185 Drive startup-sequence
information corrupted
186 Security hardware-control
logic failed
187 VPD serial number not set
188 Bad EEPROM CRC #2
189 An attempt was made to
access the appliance with
invalid passwords
201 Memory test error
229 Cache error
262 DRAM parity configuration
error
289 DIMM has been disabled by
the user or system
301 Keyboard or
keyboard-controller error
303 Keyboard controller error
602 Invalid diskette boot record
FRU/action
1. Run Configuration/Setup
2. System board
3. C2 Security Switch
1. Run Configuration/Setup
2. System board
1. Run Configuration/Setup
2. System board
1. Run Configuration/Setup
2. System board
1. Run Configuration/Setup
2. System board
1. Set serial number in Setup
2. System board
1. Run Configuration/Setup
2. System board
Run Configuration/Setup, enter the administrator
password
If the appliance does not have the latest level of BIOS
installed, update the BIOS to the latest level and run the
diagnostic program again.
1. DIMM
2. System board
1. Run Configuration/Setup
2. Processor
3. Second Processor
1. Battery
2. System board
1. Run Configuration/Setup, if disabled by user
2. Disable DIMM, if not disabled by user
1. Keyboard
2. System board
1. System board
2. Keyboard
1. Diskette
2. Diskette drive
3. Cable
4. System board
Appendix D. Engine POST and diagnostic program messages
141