Text Messages; Starting The Diagnostic Programs - IBM totalstorage 326 User Reference

The following sections contain the error codes that might appear in the detailed test
log and summary log when running the diagnostic programs.
The error code format is as follows:
fff-ttt-iii-date-cc-text message
where:
fff
ttt
iii
date
cc
text message

Text messages

The diagnostic text message format is as follows:
Function Name: Result (Test Specific String)
where:
Function Name
Result Can be one of the following:
Test Specific String

Starting the diagnostic programs

To start the diagnostic programs:
1. Connect a monitor, keyboard, and mouse to your Model 326 engine.
2. Power on the Model 326 engine and watch the screen.
146
Model 326 User's Reference
The three-digit function code that indicates the function being tested when
the error occurred; for example, function code 089 is for the
microprocessor.
The three-digit failure code that indicates the exact test failure encountered.
The three-digit device ID.
The date the diagnostic test was run and the error recorded.
The check digit used to verify the validity of the information.
The diagnostic message that indicates the reason for the problem.
The name of the function being tested when the error occurred. This
corresponds to the function code (fff) given in the previous list.
Passed
The diagnostic test has completed without any errors.
Failed The diagnostic test has discovered an error.
User Aborted
You stopped the diagnostic test before it is complete.
Not Applicable
You specified a diagnostic test for a device that is not present.
Aborted
The test could not proceed because of the system configuration.
Warning
A possible problem was reported during the diagnostic test, such as
when a device that is to be tested is not installed.
This is additional information that you can use to analyze the problem.