Table of Contents
Advertisement
S
E
ETTING
THERNET
D
S
PEED AND
UPLEX
P
ARAMETERS
At the Enter Default Router IP Address prompt, enter the IP
9
address of the router that you want the LifeSize Multipoint unit
to use and press Enter.
Do not use leading zeros in the IP address.
Caution
At the Enter IP Mask prompt, enter the subnet mask and press
10
Enter.
If a subnet mask is not used, press Enter.
After you enter the subnet mask parameter, the unit updates the
boot line parameter and reboots.
At the network configuration Main menu, enter Q to save your
11
changes and allow the device to complete the boot process.
Configuration of any of the parameters other than N: Configure
Caution
default network port values may alter the function of the device and should not
be performed by an unauthorized person.
You can use the serial port to set the Ethernet speed and duplex parameters that
you want the LifeSize Multipoint to use.
We recommend that you manually set these parameters on the LifeSize
Note
Multipoint and switch to Ethernet speed 100 Mbps and full duplex.
Procedure
Access the LifeSize Multipoint through the serial port and start
1
a terminal emulator session.
If the LifeSize Multipoint is already running, you need to reboot or
Note
restart the device.
LifeSize Multipoint Unit Initial Configuration
Setting Up Your LifeSize Multipoint
17
Advertisement
Table of Contents
