Table of Contents
Advertisement
Video Processing Module Initial Configuration
S
IP
ETTING THE
A
DDRESS
20
LifeSize Multipoint Installation Guide
This section describes how to use the serial port to configure the unit with an
IP address and other address information.
The lower serial port on the LifeSize Multipoint unit front panel is used to
assign a new video processing module an IP address. You can assign the
IP address before or after you connect the hardware to the network.
Procedure
At the prompt, enter N to configure default network port values
1
and press Enter.
The default network properties screen appears as follows:
2
Enter IP Address for default Interface
Without leading zeros <172.20.35.110:ffff0000>
Enter Default Router IP Address for default Interface
Without leading zeros <current default Gateway IP
address>:
At the Enter IP address for default interface prompt, enter
3
the IP address you want to assign to the video processing
module followed by the subnet mask, in the format <IP
address:subnet mask> and press Enter.
At the Enter Default Router IP Address prompt, enter the IP
4
address of the default gateway that you want the video
processing module to use and press Enter.
Allow the unit to complete the reboot process. A new emulator
session begins.
At the Main menu, do one of the following:
5
Enter the letter for the set of parameters that you want
to configure.
Enter Q to save your changes and allow the device to
complete the boot process.
Configuration of any of the parameters other than N: Configure
Caution
default network port values may alter the function of the device and should not
be performed by an unauthorized person.
Advertisement
Table of Contents
