Connecting The Lifesize Multipoint Unit To The Lan - LifeSize Multipoint-12 Installation Manual

LifeSize Multipoint Unit Initial Configuration
C
ONNECTING THE
L S M
IFE IZE ULTIPOINT
U LAN
NIT TO THE
18 LifeSize Multipoint Installation Guide
When the message "Press any key to start configuration"
2
appears on the screen, press any key within 6 seconds.
The network configuration Main menu appears.
At the prompt, enter A to display the Advanced
3
Configuration menu and press Enter.
The Advanced Configuration menu appears.
At the prompt, enter 3 to select "Change LAN port Settings"
4
and press Enter.
At the prompt, enter the number or letter for one of the
5
following:
1 - 10Mbps Half Duplex
2 - 100Mbps Half Duplex
3 - 10Mbps Full Duplex
4 - 100Mbps Full Duplex
5 - Auto
Q - Quit
Enter this value to retain the current setting. The default setting
is Auto.
Press Enter.
6
The network configuration Main menu appears.
At the Network Configuration menu, do one of the following:
7
Enter the letter for the set of parameters that you want
to configure.
Enter Q to save your changes and allow the device to
complete the boot process.
This section describes how to connect the LifeSize Multipoint unit to the Local
Area Network (LAN).
Procedure
Connect the supplied LAN cable from your network switch to
1
the 10/100BaseT Ethernet port on the front panel of the