Table of Contents
Advertisement
LifeSize Multipoint Unit Initial Configuration
16
LifeSize Multipoint Installation Guide
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
Turn on the power to the LifeSize Multipoint unit.
5
A log of the auto-boot events appears on the computer.
When the message "Press any key to start configuration"
6
appears on the screen, press any key within 6 seconds.
The network configuration Main menu appears as follows:
Press any key to start configuration...
Main menu
N: Configure default network port values
P: Change the configuration software password
S: Configure network security level
A: Advanced configuration menu
Q: Quit
Select:
If you do not press a key before the countdown ends, the device
Caution
continues its initialization and you can only configure the device by pressing
the RST button on the front panel.
At the prompt, enter N to configure default network port values
7
and press Enter.
At the Enter IP address for Interface No. 1 prompt, enter the
8
IP address you want to assign to the LifeSize Multipoint unit
and press Enter.
Do not use leading zeros in the IP address.
Caution
Advertisement
Table of Contents
