Preparing For Installation - LifeSize Multipoint-12 Installation Manual

P
REPARING FOR
I
NSTALLATION
Table 2-1 Front Panel Components (continued)
Component
RST button
GK and MC LEDs
LOAD LED
ACT LED
ALRM LED
Ethernet LEDs
This section describes the installation requirements for installing the LifeSize
Multipoint unit.
Proper clearance at the sides of the unit to allow adequate ventilation,
and at least 20 cm clearance at the back of the unit to allow access to
cable connections
A PC with a serial port and terminal emulation software to assign the
LifeSize Multipoint an IP address
Two dedicated IP addresses—one each for the LifeSize Multipoint
and MVP units
The IP address of the default Gateway that the LifeSize Multipoint
unit will use to communicate across the network
For an H.323 environment, the IP address of the H.323 gatekeeper
with which you want the LifeSize Multipoint unit to register. (You
may choose to work without an H.323 gatekeeper or SIP proxy server
in the network. If so, ensure the auto-attendant feature is enabled.)
Description
Allows you to reset the LifeSize Multipoint unit manually.
Lights green when the LifeSize Multipoint is registered
with a gatekeeper, or when there is no gatekeeper
registered and the auto attendant feature is enabled.
Lights green when more than 50% of the LifeSize
Multipoint unit resources are in use.
Lights green to indicate that there is at least one currently
active conference on the LifeSize Multipoint.
Lights green to indicate that an error has occurred and the
LifeSize Multipoint unit requires resetting.
The top part of the Ethernet connector contains two LED
indicators. The left-hand LED lights green when the local
IP network link is active. The right-hand LED lights green
if the connection speed is 100 Mbps, and is off when the
connection speed is 10 Mbps.
Setting Up Your LifeSize Multipoint

Preparing for Installation

11