Setting Ethernet Speed And Duplex Parameters - LifeSize Multipoint 230 Installation Manual

Setting Ethernet Speed and Duplex Parameters

S E
ETTING THERNET
S
PEED AND
D
UPLEX
P
ARAMETERS
#!
18 LifeSize Multipoint 230 Installation Guide
Enter the IP address of the router associated with the segment in which
11
the unit will be installed at the Enter Default Router IP Address prompt
and press Enter.
Do not use leading zeros in the IP address.
Caution
Enter the subnet mask without leading zeros at the Enter IP Mask for
12
default device prompt and then press Enter.
If you are not using a subnet mask, press Enter.
Allow the unit to complete the reboot process. A new emulator session
13
begins.
Close the terminal emulator session.
14
Use the serial port to set the Ethernet speed and duplex parameters that you want
the LifeSize Multipoint to use.
Procedure
Access the LifeSize Multipoint through the serial port and start the
1
terminal emulator session.
If the LifeSize Multipoint is already running, you need to reboot or
Note
restart the device.
When the message "Press any key to start configuration" appears on the
2
screen, press any key within 10 seconds.
The network configuration Main menu appears.
Enter A at the prompt to display the Advanced Configuration menu, and
3
press Enter.
The Advanced Configuration menu appears.
Enter 3 at the prompt to select "Change LAN port Settings", and press
4
Enter.