Pointing The Mvp To The Controlling Lifesize Multipoint; Changing Advanced Configuration Settings - LifeSize Multipoint-12 Installation Manual

Video Processing Module Initial Configuration
P MVP
OINTING THE
C
THE ONTROLLING
L S M
IFE IZE ULTIPOINT
C A
HANGING DVANCED
C
ONFIGURATION
S
ETTINGS
22 LifeSize Multipoint Installation Guide
Enter the new security level required and press Enter.
2
The updated security level screen appears as follows:
The current security level is [0 low].
Enter a new security level (0-low, 1-medium. 2-high):
2
Board security level changing to [2 high]:
Set icmpRequestBlock to 2
The new security level is [2 high].
The video processing module Main menu displays.
3
You can use the serial port to point the MVP to the IP address of the controlling
TO
LifeSize Multipoint unit.
Procedure
At the prompt, enter M to change the LifeSize Multipoint IP
1
address and press Enter.
The LifeSize Multipoint IP address screen displays as follows:
Enter MCU ip address
Without leading zeros <current IP address>:
Enter the IP address of the LifeSize Multipoint and press any
2
key to return to the MVP Main menu.
You can use the serial port to change the following advanced configuration
settings:
Web server port (for future use)
Restore factory configuration (for future use)
LAN port settings
Disable DSP reset